Quick Answer: Where Is The Transporter Barcode For The Toll Roads?

0 Comments

Where do you put the transponder sticker?

Place the sticker transponder in the lower left-hand corner or lower right-hand corner of the inside of the windshield. Or, place it behind the rearview mirror on the inside of the windshield (Consider visual aesthetics from inside and outside of the vehicle when choosing the location.)

How do I get a FasTrak sticker?

If you have a vehicle with a metalized windshield listed on your account, you can request an external headlamp sticker transponder by logging into your account at TheTollRoads.com. Once logged in, select “Transponders” and “Request” a headlamp sticker.

What is a switchable transponder?

Switchable FasTrak transponder (s) are required on certain tolled bridges, lanes and roads in California to recieve discounted rates or free rides for carpooling and/or high occupancy vehicles. If you have both, your sticker transponder and switchable transponder can be mounted to your windshield at the same time.

Can I drive on FasTrak without transponder?

Yes. FasTrak drivers must have a transponder mounted to their vehicle’s windshield. State law requires a transponder to be in the vehicle or valid license plates properly mounted to the vehicle.

You might be interested:  Often asked: Where Do I Print My Lime Account Barcode?

Can I put FasTrak on dashboard?

Please be aware that simply having the FasTrak on your dashboard or in your vehicle and not in one of the locations provided with your FasTrak transponder may result in a citation from the California Highway Patrol.

Where is the best place to put EZ Pass?

Locate the correct position for the tag — the upper center portion of your windshield behind the rearview mirror, at least 1 inch to the right of the mirror and at least 1 inch below the top edge of the windshield.

How do I put on an EZ tag?

  1. Apply new EZ TAG to windshield Holding the tag by the edges, press on the center of the tag using your index finger.
  2. Remove protective layer from new EZ TAG.
  3. Mounting location Use the EZ TAG ruler above to measure 4″ down from the top of the windshield, behind the right side of the rearview mirror.

Where do I place my sunpass mini?

Press your transponder against the windshield to enable the suction cups to stick. Transponder must be placed a minimum of 2 inches below the windshield frame. If the windshield has a solar strip, install the transponder at least 2 inches below the strip.

Is it worth it to get a FasTrak?

YES. FASTRAK IS ALWAYS WORTH IT.

What happens if you go through FasTrak without a pass?

If you use an express lane without a valid FasTrak toll tag, you will receive a violation notice. The following is a schedule of toll evasion penalties: First notice issued: $25 penalty. Second (delinquent) notice issued: $70 ($25 penalty plus $45 late fee).

You might be interested:  What Is The Barcode For Ralphs Ground Beef 85%?

How much is a FasTrak sticker?

Sticker transponders are free. FasTrak Invoice accounts will continue to be assessed an additonal $2 invoice fee per statement.

How much does a transponder cost?

Ohio’s E-ZPass system has a yearly fee of $9.00 and requires a $3 deposit to activate the transponder. A minimum balance of $25 per transponder is required to establish the account. When the balance reaches or falls below $10, the account auto-replenishes to $25. E-ZPass Costs by State.

State Yearly Fee
Illinois
Delaware

12

What is a switchable 3 position transponder?

The FasTrak Flex transponder also has a three – position switch which is used in some toll facilities to receive carpool discounts. You set the switch position. The switch can be moved to display the number of people in your vehicle before starting your trip. This information is then relayed to the roadside equipment.

What does HOV 3+ mean?

Answers to FAQs About High Occupancy Vehicle ( HOV ) Facilities. What is an HOV lane? An HOV lane, sometimes called a carpool lane, is a special lane reserved for the use of carpools, vanpools and buses. Lanes are identified as “2+” or ” 3 +” which refers to the minimum number of occupants to qualify.

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post